This time we put a new holography to lure old and very worn.
As you can see it is a Shore Line 170 mm.
At the end of the process, with two coats of epoxy and the two get about 4 grams but, with this win more set, and will not affect anything in depth or swimming lure.
At the end of the process, with two coats of epoxy and the two get about 4 grams but, with this win more set, and will not affect anything in depth or swimming lure.
First with a Stanley knife, fine sandpaper or a dremel, sand it until it was all the bait as in the picture above.
chose holography we're going to place and cut to size
We make cuts where we were on or not wearing (in this case to rid the gills)
We stick with a strong adhesive, loctite or a similar one, and cut the excess.
In this case we only need to be trimmed from the top since the paper was well-suited to the bottom.
have already attached and ready for the next step.
The next step is to put the dots of sardines, so it is like the original, but that's a consumer taste.
In this case it was made with the rear end of a brush and very striking, uff.
After allowing to dry the black dots (allow to dry thoroughly and according to the manufacturer says) give a coat of varnish, in this case is a dual-layer coating mixed with a catalyst for create hardness.
A Once dry, give one or two coats of an epoxy, either fast or slow drying.
I prefer fast and the slow can take 10 days to complete Quick drying and dry in 5 minutes and is best applied.
Between coats of epoxy a small lijadita with a fine waterproof sandpaper.
To epoxy layers of the best ways for me is give it the finger, but that if covered with a vinyl glove, nitrile or latex.
We'll give the front and turning back so we are not left with bald patches or lumps, giving the finger until we see that draws and no longer runs fine finger.
Finally after dry sanding will give you another fine and another layer of varnish.
Finally after dry sanding will give you another fine and another layer of varnish.
And finally a video where you can see the finish and as with the epoxy to get that there are no corners or edges that could catch the triple
Greetings, we are by the mason